Home

RFC4574

  1. RFC 4574
Network Working Group                                           O. Levin
Request for Comments: 4574                         Microsoft Corporation
Category: Standards Track                                   G. Camarillo
                                                                Ericsson
                                                             August 2006


         The Session Description Protocol (SDP) Label Attribute

Status of This Memo

   This document specifies an Internet standards track protocol for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "Internet
   Official Protocol Standards" (STD 1) for the standardization state
   and status of this protocol.  Distribution of this memo is unlimited.

Copyright Notice

   Copyright (C) The Internet Society (2006).

Abstract

   This document defines a new Session Description Protocol (SDP)
   media-level attribute: "label".  The "label" attribute carries a
   pointer to a media stream in the context of an arbitrary network
   application that uses SDP.  The sender of the SDP document can attach
   the "label" attribute to a particular media stream or streams.  The
   application can then use the provided pointer to refer to each
   particular media stream in its context.

Table of Contents

   1. Introduction ....................................................2
   2. Terminology .....................................................2
   3. Motivation for the New label Attribute ..........................2
   4. The Label Attribute .............................................3
   5. The Label Attribute in the Offer/Answer Model ...................4
   6. Example .........................................................4
   7. Security Considerations .........................................4
   8. IANA Considerations .............................................5
   9. Acknowledgements ................................................5
   10. References .....................................................6
      10.1. Normative References ......................................6
      10.2. Informative References ....................................6






Levin & Camarillo           Standards Track                     [Page 1]
RFC 4574                  SDP Label Attribute                August 2006


1.  Introduction

   SDP is being used by a variety of distributed-over-the-network
   applications.  These applications deal with multiple sessions being
   described by SDP [4] and serving multiple users or services in the
   context of a single application instance.  Applications of this kind
   need a means to identify a particular media stream across multiple
   SDP descriptions exchanged with different users.

   The XCON framework is an example of a centralized conference
   architecture that uses SDP according to the offer/answer mechanism
   defined in [3] to establish media streams with each of the conference
   participants.  Additionally, XCON identifies the need to uniquely
   identify a media stream in terms of its role in a conference
   regardless of its media type, transport protocol, and media format.
   This can be accomplished by using an external document that points to
   the appropriate media stream and provides information (e.g., the
   media stream's role in the conference) about it.  The SIP Event
   Package for Conference State [7] defines and uses a concrete format
   for such external documents.

   This specification defines the SDP [4] "label" media-level attribute,
   which provides a pointer to a media stream that is described by an
   'm' line in an SDP session description.

2.  Terminology

   In this document, the key words "MUST", "MUST NOT", "REQUIRED",
   "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT
   RECOMMENDED", "MAY", and "OPTIONAL" are to be interpreted as
   described in BCP 14, RFC 2119 [1] and indicate requirement levels for
   compliant implementations.

3.  Motivation for the New label Attribute

   Even though SDP and its extensions already provide a few ways to
   refer to a media stream, none of them is appropriate to be used in
   the context of external documents that may be created before the
   session description itself and need to be handled by automata.

   The 'i' SDP attribute, defined in RFC 2327 [4], can be used to label
   media streams.  Nevertheless, values of the 'i' attribute are
   intended for human users and not for automata.








Levin & Camarillo           Standards Track                     [Page 2]
RFC 4574                  SDP Label Attribute                August 2006


   The 'mid' SDP attribute, defined in RFC 3388 [6], can be used to
   identify media streams as well.  Nevertheless, the scope of 'mid' is
   too limited to be used by applications dealing with multiple SDP
   sessions.  This is because values of the 'mid' attribute are
   meaningful in the context of a single SDP session, not in the context
   of a broader application (e.g., a multiparty application).

   Another way of referring to a media stream is by using the order of
   the 'm' line in the SDP session document (e.g., the 5th media stream
   in the session description).  This is the mechanism used in the
   offer/answer model [3].

   The problem with this mechanism is that it can only be used to refer
   to media streams in session descriptions that exist already.  There
   are scenarios where a static document needs to refer, using a
   pointer, to a media stream that will be negotiated by SDP means and
   created in the future.  When the media stream is eventually created,
   the application needs to label the media stream so that the pointer
   in the static document points to the proper media stream in the
   session description.

4.  The Label Attribute

   This specification defines a new media-level value attribute:
   'label'.  Its formatting in SDP is described by the following ABNF
   [2]:

      label-attribute    = "a=label:" pointer

      pointer            = token

      token              = 1*(token-char)

      token-char         = %x21 / %x23-27 / %x2A-2B / %x2D-2E / %x30-39
                           / %x41-5A / %x5E-7E

   The token-char and token elements are defined in [4] but included
   here to provide support for the implementor of this SDP feature.

   The 'label' attribute contains a token that is defined by an
   application and is used in its context.  The new attribute can be
   attached to 'm' lines in multiple SDP documents allowing the
   application to logically group the media streams across SDP sessions
   when necessary.







Levin & Camarillo           Standards Track                     [Page 3]
RFC 4574                  SDP Label Attribute                August 2006


5.  The Label Attribute in the Offer/Answer Model

   This specification does not define a means to discover whether or not
   the peer endpoint understands the 'label' attribute because 'label'
   values are informative only at the offer/answer model level.

   At the offer/answer level, it means that the fact that an offer does
   not contain label attributes does not imply that the answer should
   not have them.  It also means that the fact that an offer contains
   label attributes does not imply that the answer should have them too.

   In addition to the basic offer/answer rule above, applications that
   use 'label' as a pointer to media streams MUST specify its usage
   constraints.  For example, such applications MAY mandate support for
   'label'.  In this case, the application will define means for
   negotiation of the 'label' attribute support as a part of its
   specification.

6.  Example

   The following is an example of an SDP session description that uses
   the 'label' attribute:

      v=0
      o=bob 280744730 28977631 IN IP4 host.example.com
      s=
      i=A Seminar on the session description protocol
      c=IN IP4 192.0.2.2
      t=0 0
      m=audio 6886 RTP/AVP 0
      a=label:1
      m=audio 22334 RTP/AVP 0
      a=label:2

7.  Security Considerations

   An attacker may attempt to add, modify, or remove 'label' attributes
   from a session description.  This could result in an application
   behaving in a non-desirable way.  So, it is strongly RECOMMENDED that
   integrity protection be applied to the SDP session descriptions.  For
   session descriptions carried in SIP [5], S/MIME is the natural choice
   to provide such end-to-end integrity protection, as described in RFC
   3261 [5].  Other applications MAY use a different form of integrity
   protection.







Levin & Camarillo           Standards Track                     [Page 4]
RFC 4574                  SDP Label Attribute                August 2006


8.  IANA Considerations

   The IANA has registered the following new SDP attribute:

   Contact name:          Orit Levin oritl@microsoft.com.

   Attribute name:        "label".

   Type of attribute:     Media level.

   Subject to charset:    Not.

   Purpose of attribute:  The 'label' attribute associates a media
   stream with a label.  This label allows the media stream to be
   referenced by external documents.

   Allowed attribute values:  A token.

9.  Acknowledgements

   Robert Sparks, Adam Roach, and Rohan Mahy provided useful comments on
   this document.





























Levin & Camarillo           Standards Track                     [Page 5]
RFC 4574                  SDP Label Attribute                August 2006


10.  References

10.1.  Normative References

   [1]  Bradner, S., "Key words for use in RFCs to Indicate Requirement
        Levels", BCP 14, RFC 2119, March 1997.

   [2]  Crocker, D., Ed. and P. Overell, "Augmented BNF for Syntax
        Specifications: ABNF", RFC 4234, October 2005.

   [3]  Rosenberg, J. and H. Schulzrinne, "An Offer/Answer Model with
        Session Description Protocol (SDP)", RFC 3264, June 2002.

   [4]  Handley, M., Jacobson, V. and C. Perkins, "SDP: Session
        Description Protocol", RFC 4566, July 2006.

10.2.  Informative References

   [5]  Rosenberg, J., Schulzrinne, H., Camarillo, G., Johnston, A.,
        Peterson, J., Sparks, R., Handley, M., and E. Schooler, "SIP:
        Session Initiation Protocol", RFC 3261, June 2002.

   [6]  Camarillo, G., Eriksson, G., Holler, J., and H. Schulzrinne,
        "Grouping of Media Lines in the Session Description Protocol
        (SDP)", RFC 3388, December 2002.

   [7]  Rosenberg, J., Schulzrinne, H., and O. Levin, "A Session
        Initiation Protocol (SIP) Event Package for Conference State",
        RFC 4575, August 2006.






















Levin & Camarillo           Standards Track                     [Page 6]
RFC 4574                  SDP Label Attribute                August 2006


Authors' Addresses

   Orit Levin
   Microsoft Corporation
   One Microsoft Way
   Redmond, WA  98052
   USA

   EMail: oritl@microsoft.com


   Gonzalo Camarillo
   Ericsson
   Hirsalantie 11
   Jorvas  02420
   Finland

   EMail: Gonzalo.Camarillo@ericsson.com

































Levin & Camarillo           Standards Track                     [Page 7]
RFC 4574                  SDP Label Attribute                August 2006


Full Copyright Statement

   Copyright (C) The Internet Society (2006).

   This document is subject to the rights, licenses and restrictions
   contained in BCP 78, and except as set forth therein, the authors
   retain all their rights.

   This document and the information contained herein are provided on an
   "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
   OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET
   ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED,
   INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE
   INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
   WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Intellectual Property

   The IETF takes no position regarding the validity or scope of any
   Intellectual Property Rights or other rights that might be claimed to
   pertain to the implementation or use of the technology described in
   this document or the extent to which any license under such rights
   might or might not be available; nor does it represent that it has
   made any independent effort to identify any such rights.  Information
   on the procedures with respect to rights in RFC documents can be
   found in BCP 78 and BCP 79.

   Copies of IPR disclosures made to the IETF Secretariat and any
   assurances of licenses to be made available, or the result of an
   attempt made to obtain a general license or permission for the use of
   such proprietary rights by implementers or users of this
   specification can be obtained from the IETF on-line IPR repository at
   http://www.ietf.org/ipr.

   The IETF invites any interested party to bring to its attention any
   copyrights, patents or patent applications, or other proprietary
   rights that may cover technology that may be required to implement
   this standard.  Please address the information to the IETF at
   ietf-ipr@ietf.org.

Acknowledgement

   Funding for the RFC Editor function is provided by the IETF
   Administrative Support Activity (IASA).







Levin & Camarillo           Standards Track                     [Page 8]
  1. RFC 4574